Jeep WRANGLER 4Xe 2022 Manual page 45

NOTE:
Older or non-compliant J1772 EVSE models

may not support charging of this vehicle. If this
vehicle does not charge, it may be connected to
a non-compliant Level 2 EVSE, and will flash
indicators. Please identify this failure to the site
operator and/or EVSE provider.
Before this vehicle can be driven, the EVSE

Charging Cord must be disconnected from the
vehicle.
Torque Limited Warning Light
This warning light illuminates when
vehicle acceleration is limited due to a
reduction in engine or electric motor
performance. Contact an authorized
dealer for service if illumination persists.
G I L
REEN NDICATOR IGHTS
Ready To Drive Indicator Light
This indicator light will illuminate to
indicate that the vehicle has enough
power to be driven, regardless of the
speed of the vehicle.
Plug Status Indicator Light
When plugged in, the green plug
indicator light will illuminate if the Electric
Vehicle Supply Equipment (EVSE)
charging plug is securely attached to the
charging port. This indicates that the plug is
detected, but doesn't mean it is charging. It will be
accompanied with a cluster message indicating
the charge status:
"Plugged In And Charging"

"Plugged In And Waiting to Charge On A

Set Schedule"
"Plugged in and Charging Complete"

NOTE:
The vehicle cannot be driven until it is unplugged.
Max Regeneration Indicator Light
This indicator light will illuminate to
indicate that Max Regeneration is on and
capable.
When the switch is pressed, the following
instrument cluster messages will be seen:
"Max Regeneration On" – appears when the

feature is turned on.
"Max Regeneration Off" – appears when the

feature is turned off.
"Max Regeneration Unavailable" – appears

when the feature is requested, but the vehicle is
unable to comply. LED will flash for five seconds
to indicate unavailability Ú page 8.
GETTING TO KNOW YOUR INSTRUMENT PANEL
W I L
HITE NDICATOR IGHTS
Max Regeneration Indicator Light
This indicator light will illuminate to
indicate that Max Regeneration is on and
not ready.
When the switch is pressed, the following
instrument cluster messages will be seen:
"Max Regeneration On" – appears when the

feature is turned on.
"Max Regeneration Off" – appears when the

feature is turned off.
"Max Regeneration Unavailable" – appears

when the feature is requested, but the vehicle is
unable to comply. LED will flash for five seconds
to indicate unavailability Ú page 8.
43
3