OPERATING INSTRUCTIONS
• Connect the power cable to a 220-240V, 13 amp supply that
is located in a safe, dry area.
• The heater must be properly installed before it is used.
• Only operate the heater when it is in the upright position.
• This unit is equipped with three heat settings.
Touch
Switch
• Push the On/Off switch to the "I" position to activate the
heater; this is inside the hollow section in the centre of the
heater.
• Touch the touch switch once, the heater will be set to
1000W power.
• Touch the touch switch twice, the heater will be set to
1500W power.
• Touch the touch switch three times, the heater will be set to
2500W power.
• Touch the touch switch four times, the heater will be set to
2500W power and the LED light will be turned on.
• Touch the touch switch five times, the heater will be on
standby and just the LED light will be turned on.
• Touch the touch switch six times, the LED light will be turned
off.
• To completely turn off the patio heater, push the On/Off
switch to the "O" position.
15
On/Off
Switch
Revision 1.2