Operating Instructions - Zanussi ZTPTH1 Manual & Safety Instructions

OPERATING INSTRUCTIONS

• Connect the power cable to a 220-240V, 13 amp supply
that is located in a safe, dry area.
• The heater must be properly installed before it is used.
• Only operate the heater when it is in the upright position.
• This unit is equipped with one heat setting: On I Off.
Pull Cord
Switch
• Pull the pull cord switch once to turn on the patio heater.
• Pull the pull cord switch again to turn the patio heater
off.
• WARNING: Although the patio heater is shower proof, do
not use when raining or in wet conditions.
• WARNING: Always disconnect the power cable from the
electrical supply when the patio heater is not in use.
13 Revision 1.3