Table of Contents
Advertisement
BASIC OPERATION
12. Coax/Cable/DSS Surge Protection
The Coax/Cable/DSS protection ports will
protect any cable modem, CATV converter,
or DSS receiver.
REPLACING THE BATTERY
Replacement of batteries located
in an OPERATOR ACCESS AREA
1. When replacing batteries, replace
with the same number of the following
battery: CyberPower / RB1290 for the
CP850/1000AVRLCD; CyberPower /
RB1290X2 for the CP1350/1500AVRLCD
2. CAUTION! Risk of Energy Hazard, 12 V,
maximum 9 Ampere-hour battery for
CP850/1000AVRLCD; 24 V, maximum
9 Ampere-hour battery for
CP1350/1500AVRLCD.
Before replacing batteries, remove conduc-
tive jewelry such as chains, wrist watches,
and rings. High energy conducted through
these materials could cause severe burns.
BATTERY REPLACEMENT PROCEDURE:
CP850/1000/1500AVRLCD
1. Turn off and unplug all connected equipment.
2. Turn the UPS off and unplug it from the AC power source.
3. Turn the UPS on its side.
4. Remove the front panel retaining screws located on the bottom of the UPS.
5. Slide the battery compartment cover (front panel) completely off of the unit.
CP850/1000AVRLCD
CP1500AVRLCD
- continued
13. Widely-spaced Outlets
The unit has two outlets spaced to allow AC
power adapter blocks to be plugged into the
UPS without blocking adjacent outlets.
3. CAUTION! Do not dispose of batteries in a
fire. The batteries may explode
4. CAUTION! Do not open or mutilate
batteries. Released material is harmful
to the skin and eyes. It may be toxic.
5. CAUTION: A battery can present a risk
of electrical shock and high short circuit
current. The following precautions should
be observed when working on batteries:
1) Remove watches rings, or other
metal objects.
2) Use tools with insulated handles.
CAUTION - RISK OF EXPLOSION IF BATTERY
IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO LOCAL REGULATIONS
Advertisement
Table of Contents
