Table of Contents
Advertisement
SONAR VIEW SOFTWARE INSTALLATION FOR PLAYBACK ONLY
Use this install to put SONAR VIEW on computers that will only be used to playback previously
recorded files.
1. Start PC
2. Insert SONAR VIEW Installation CD into CD or DVD drive.
3. The SONAR VIEW Installation program should auto-run. If it does not, skip to step 5.
4. Exit the SONAR VIEW Installation program without installing any software.
5. Open Windows Explorer from the Start / Programs menu or right click on the Start button and select Explore
from the menu.
6. Select Jwf – SONAR VIEW . Open the SONAR VIEW folder. Click on Setup. This will start the SONAR VIEW
installation program.
7. The 'Welcome to JW Fishers SONAR VIEW Setup Wizard' box opens. Click 'Next' to continue.
8. The customer information box opens "Enter your name, organization, and the software serial number provided
by JW Fishers. Click 'Next'.
9. The 'Confirm Installation' box opens. Click 'Next'.
10. The "Select Installation Folder' box opens. The default folder is C:\ Program Files\. This should only be changed
if either the Windows or Program Files folder is not located on the C:\ drive. Click 'Next'.
11. The SONAR VIEW software installation will complete. Click 'Close' in the 'Installation Complete' box.
12. Remove the Installation CD from the drive now.
13. SONAR VIEW is now ready to run for playback only.
14. When running SONAR VIEW a warning will appear:
"A Required Interface board was not found, Recording has been disabled".
Click ok to enter playback only mode.
46
Advertisement
Table of Contents
