JW Fishers SSS-100K PC Operation And Maintenance Manual page 44

INSTALLING HARDWARE AND SOFTWARE (continued)
When you first connect the Sonar Processor SP to PC Interface (USB Cable), the Windows "Found
New Hardware Wizard will launch.
1. The first message box will state: 'Can Windows Connect to Windows update to search for
software?' Select 'No, not this time.' then click 'Next' to continue.
2.The next screen states: 'If your hardware came with an installation CD of Floppy, insert it now The
drivers have already been installed on the PC. It is not necessary to insert the CD. Select 'Install the
software automatically (Recommended)', then click 'Next' to continue.
InstaCal program - Interface board configuration and calibration
Before the SONAR VIEW can be used for the first time, this program must be run to configurethe
Interface board which is integrated into the Sonar Processor. This program must also be run
whenever the Sonar Processor is used with a different PC. The SP to PC interface (USB Cable)
must be connected before running this program.
1. From the Start menu select Programs / Measurement Computing / InstaCal.
2. The InstaCal software starts.
3. A 'Plug and PlayBoard Detection' window should open. USB-1208HS should show in the
window. Click 'OK'
4. 'Board #0 - USB-1208HS' should show in the board list window.
5. From the 'Install' pull-down menu click on 'Configure'. The 'Board Configuration' box opens.
6. • Next to 'Number of Channels', select '8 Single Ended'. fromthe drop down list.
• Click 'OK' to continue.
7. Exit the InstaCal program.
SONAR VIEW SOFTWARE INSTALLATION IS CONTINUED ON NEXT PAGE
44