Table of Contents
Advertisement
Do not use aggressive means for cleaning the workshop floor and the automotive lift.
A permanent contact with every kind of liquid is forbidden. Do not use any high
pressure device for cleaning the lift.
6.2 Adjust the Polylex-belt
If the belt was exchanged, the belt must be adjusted. Remove the cover of the belt.
(pic.4).
The new belt tension must be adjusted at the stretch device. (pic.5). Loose the three
screws at the motor easily. (pic. 6, No.1). The belt can be loosened or tightened at the
screws. (pic.6, No.2).
The belt tension gets adjusted with the help of an accessory. (pic. 7; This accessory can
be ordered from Nussbaum Hebetechnik (Order number 225SL13000).
Operating Instruction and Documentation
Pic.4: cover of the belt (version with raising pipe)
1: column
2: raising pipe
3: cover of the belt
4: spindle
Pic.5: position of the belt
1: raising pipe (optional)
2: stretch device
3: V-belt pulley
4: Polyflex-belt
5: shaft of the motor
pic.6: adjust the belt tension
1: the three screws of the motor
2: adjusting screws
Pic.7: accessory
- 15 -
2.30 SL E
Advertisement
Table of Contents
