Installation And Operating Instructions; Checks Before Installation; How To Remove Panels - Hoshizaki KM-2400SRH3 Instruction Manual

Stackable crescent cuber

Hide thumbs Also See for KM-2400SRH3:

Table of Contents

II. INSTALLATION AND OPERATING INSTRUCTIONS

1. Remove shipping carton, tape(s) and packing. If packing material is left in the

icemaker, it will not work properly.

2. Ensure all components, fasteners and thumbscrews are securely in place.

1) Remove the panels to prevent damage when installing the icemaker. (See "2. HOW TO

REMOVE PANELS.")

2) Remove the package containing the accessories from the compressor compartment.

3) Remove the protective plastic film from the panels. If the icemaker has been exposed to the

sun or to heat, remove the film after the icemaker cools.

4) Check that the refrigerant lines do not rub or touch lines or other surfaces.

5) Check that the Compressor is snug on all mounting pads.

6) See the Nameplate on the Rear Panel, and check that your voltage supplied corresponds

with the voltage specified on the Nameplate.

7) This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE

STORAGE BIN, Model B-800 series.

8) On remote air-cooled models, a remote condenser unit is needed. The recommended

remote condenser unit is HOSHIZAKI CONDENSER UNIT, Model URC-24F.

2. HOW TO REMOVE PANELS - See Fig. 1

a) Front Panel .......... Remove the two screws.

b) Top Panel ............ Remove the two screws,

c) Side Panel (R) ..... Remove the screw.

d) Insulation Panel .. Remove the Thumbscrew.

IMPORTANT

Lift up and pull toward you.

and then lift off.

Pull slightly toward you,

and take off.

Lift up slightly, and pull toward

you.

Fig. 1

Table of Contents

Show Quick Links

Table of Contents