Installation And Operating Instructions; Checks Before Installation; How To Remove Panels - Hoshizaki KM-2000SRF3 Instruction Manual

II. INSTALLATION AND OPERATING INSTRUCTIONS

1. CHECKS BEFORE INSTALLATION

Remove shipping carton, tape(s) and packing. If packing material is left in the
icemaker, it will not work properly.
1) Remove the panels to prevent damage when installing the icemaker. (See "2. HOW TO
REMOVE PANELS.")
2) Remove the package containing the accessories from the compressor compartment.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the sun
or to heat, remove the film after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces.
5) Check that the Compressor is snug on all mounting pads.
6) See the Nameplate on the Rear Panel, and check that your voltage supplied corresponds
with the voltage specified on the Nameplate.
7) This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE
STORAGE BIN, Model B-800 series.
8) On remote air-cooled models, a remote condenser unit is needed. The recommended
remote condenser unit is HOSHIZAKI CONDENSER UNIT, Model URC-20F.
2. HOW TO REMOVE PANELS - See Fig. 1
a) Front Panel ......... Remove the two screws.
b) Top Panel ............ Remove the two screws,
c) Side Panel (R) ..... Remove the screw.
d) Insulation Panel .. Remove the Thumbscrew.
A1EA10A0007
IMPORTANT
Lift up and pull toward you.
and then lift off.
Pull slightly toward you,
and take off.
Lift up slightly, and pull toward
you.
8
Fig. 1