Installation And Operating Instructions; Checks Before Installation; How To Remove Panels - Hoshizaki KM-1340MAH Instruction Manual

II. Installation and Operating Instructions
A. Checks Before Installation
1. Remove shipping carton, tape(s) and packing. If packing material is left in
the icemaker, it will not work properly.
2. Ensure all components, fasteners and thumbscrews are securely in place.
1) Remove the panels to prevent damage when installing the icemaker. (See "B. How to
Remove Panels.")
2) Remove the package containing the accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade turns freely.
5) Check that the compressor is snug on all mounting pads.
6) See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
7) This icemaker needs a storage bin. The recommended storage bin is HOSHIZAKI ICE
STORAGE BIN, Model B-500 series.
8) On remote air-cooled models, a remote condenser unit is needed. The recommended
remote condenser unit is HOSHIZAKI CONDENSER UNIT, Model URC-14F.
B. How To Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and pull
towards you.
• Top Panel: Lift up its front slightly, push away,and
then lift off.
• Side Panel (R): Remove the screw. Pull slightly
towards you, and lift off.
• Insulation Panel: Lift up slightly, and pull towards you.
Note: If the top panel is still on, first lift it
and slide it to the back a little.
IMPORTANT
10
Fig. 1