Table of Contents
Advertisement
Adjusting your monitor image
This section describes the user control features used to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Table 2-1. Direct access controls
Using the On-Screen Display (OSD) controls
The settings adjustable with the user controls are viewed through the On-Screen Display (OSD),
as shown below.
To use the controls:
1. Press
2. Use
3. Press
4. Press and hold
5. Enables DDC/CI by default. Use OSD Exit Key, press and hold the
Icon
Control
Image Setup
Brightness
Low Blue Light
Main menu
to open the main OSD menu.
or
to move among the icons. Select an icon and press
function. If there is a sub-menu, you can move between options using
press
to select that function. Use
save.
to move backwards through the sub-menus and exit from the OSD.
for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold
and allow adjustments to the OSD.
seconds to disable/enable DDC/CI function. The words " DDC/CI
Disable/DDC/CI/Enable" shows on the screen.
Description
Activates automatic image adjustment.
Direct access to Brightness adjustment.
Press and hold for 3 seconds
enable/disable Low Blue Light.
Open OSD main menu
or
to make adjustments. Press
for 10 seconds to unlock the OSD
Chapter 2. Adjusting and Using your monitor 2-4
to
to access that
or
,
then
to
buttons for 10
Advertisement
Table of Contents
