Information on the display panel
Display
The door cannot be
locked, please open the
door again, then close it
and select "start/pause".
i
Please re-fill i-Dos
ô
i-Dos
container
ô
ô
i
i-Dos
I
, i-Dos
error; deactivate
ô
ô
i
i-Dos
I
, i-Dos
Please close detergent
drawer.
Please open tap
Please clean pump
Pause: Reload is not
possible
Door cannot be
unlocked: Water level or
temperature is too high
aquaStop has been
activated!
Please call customer
service
Auto power-off in ...
seconds,
Water cooling
Other displays
Error E: XXX
Cause/Remedy
– Washing may be caught. Please open and close washing
machine door again and select Start/Reload
– If required, shut washing machine door or remove washing
and shut again.
– If required, switch appliance off and on again; set
programme and make individual settings; start programme.
Level i-Dos container below minimum, Top up ~ Page 32
ô
I
,
ô
i
Set i-Dos
I
Call customer Service. Appliance can continue to be operated
with manual dosage. ~ Page 36
Push in detergent drawer correctly. ~ Page 32
– Turn on tap fully.
– Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 44
– Drain pump blocked. Clean the drain pump.
– The water drainage pipe/drain hose is blocked. Clean the
drainage hose on the siphon. ~ Page 44
Water level or temperature is too high.
Select Start/Reload
Water level or temperature is too high.
Select Start/Reload
not applicable without Aqua-Stop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 50
Appliance automatically switches off after ... seconds if it is not
operated for a prolonged period. In order to cancel the
programme, press any button. ~ Page 38
To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service. ~ Page 50
ô
, i-Dos
to off.
Ü
to continue the programme.
Ü
to continue the programme.
Ü
.
47