Siemens WM16Y891GC Instruction Manual And Installation Instructions page 44

Table of Contents

Advertisement

7.
²
To prevent unused detergent from flowing into the outlet during
the next wash cycle: Pour approx. 1 litre of water into
dispenser
Drainage hose on the siphon blocked
1.
Note: Residual water may run out!
2.
3.
4.
Filter blocked in water inlet hose
First, release water pressure in the supply hose:
1.
2.
3.
4.
5.
44
Insert service flap (1), engage (2) and close (3).
À Á
and start the Drain programme.
Switch off the appliance. Pull out the mains plug!
Loosen hose clip, carefully remove drainage hose.
Clean drainage hose and siphon spigot.
Re-attach drainage hose and secure connection point with
hose clip.
Turn off the tap!
Select any programme (except Spin/Drain).
Select Start/Reload
seconds.
#
Press the
button. Appliance is switched off. Pull out the
mains plug!
Clean the filter:
Disconnect the hose from the water tap.
Clean filter with small brush.
and/or for standard and Aqua-Secure models:
Ü
. Leave programme for approx. 40

Advertisement

Table of Contents
loading

Table of Contents