Siemens WM16Y891GC Instruction Manual And Installation Instructions page 34

Ø
Standard settings
Ø
Degree of soiling ヾ
Water hardness ゝ
soft/medium
hard/very hard
²
– Factory setting of the basic dosage: for detergent 75 ml and
– In the case of more concentrated detergents reduce the
34
Reloading detergent/softener
The flashing of the associated illuminated display when
intelligent dosage is selected and a corresponding message
on the display panel indicate that the level is below the
minimum. There are still enough contents for approx.
3 washes.
The same detergent or softener can be topped up at any
time. If the product/manufacturer is changed, we recommend
cleaning the dispensers beforehand. ~ Page 41 If required,
adjusting the basic dosage. ~ Page 34
If required, change basic dosages for detergent and softener:
The basic dosage amount to be set corresponds:
For detergents – to the manufacturer's recommendation for
normal soiling and to the particular water hardness.
For softeners – to the manufacturer's recommendation for
medium softness and to the particular water hardness.
This information can be found on the package label of the
detergent/softener or ask the manufacturer directly.
To determine the existing water hardness, use a test strip or
check with your water utility company.
My water hardness:
Here is an example of the detergent dosage on a package
label:
for softener 36 ml.
basic dosage amount.
light normal
55 ml 75 ml
75 ml 95 ml
heavy very
heavy
120 ml 160 ml
150 ml 180 ml