Shark HYDROVAC WD100 Series Owner's Manual page 6

MAINTAINING YOUR 3-IN-1 CLEANER
5. After cleaning the dirty water tank and the solids
separator, allow them to air-dry in a well-ventilated
area for at least 24 hours. To reinstall the tank, insert
the bottom into the opening in the main body, then
tilt the tank back until it clicks into place.
CHECKING FOR BLOCKAGES
If you run over a hard or sharp object or notice a noise change while using your unit, check for blockages or
objects caught in the brushroll, nozzle chamber, or inlet hose.
s h a r kc l e a n . c o m
5
1. Turn off the power.
2. Remove the brushroll cover, brushroll, and dirty
water tank.
3. Check the openings and remove all debris.
4. When finished, reinstall the brushroll and the cover.
MAINTAINING YOUR 3-IN-1 CLEANER
TROUBLESHOOTING
WARNING: To reduce the risk of shock and unintended operation, turn off power before servicing.
LED INDICATOR WHAT IT MEANS
The Water Droplet LED is
pulsing red. The dirty water tank is full.
The Water Droplet LED is
The clean solution tank is
pulsing aqua.
empty.
The Area Rug icon and the
three water droplet lights are
flashing red at the same time. Brushroll cover is not installed
properly.
The Area Rug icon and the
three water droplet lights
are flashing red out of sync.
The brushroll is jammed.
Self-Clean icon and droplets
Not enough solution to run
are flashing blue.
Self-Clean Cycle.
Self-Clean icon and droplets
Dirty water tank is full and
are flashing red.
preventing Self-Clean Cycle to run.
NOTE: If 3-in-1 Cleaner still does not operate properly, contact Customer Service at 1 800 798 7398 or
sharkclean.com/support
WHAT TO DO
Empty the fluid in the dirty
water tank.
*If this is a false error, remove
solids separator and clean
completely. Allow part to dry
for 24 hours or dry manually.
Fill the clean solution tank.
Refer to the "Filling the Clean
Solution Tank" section.
Refer to the "Cleaning the
Brushroll" section, step 4
Turn off the power before
cleaning the brushroll and any
debris that may be causing
the jam. Refer to the "Cleaning
the Brushroll" section.
Fill clean solution tank to
allow self-clean cycle to run.
Empty dirty water tank to
allow self-clean cycle to run.
s h a r kc l e a n . c o m