Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Candy CDG6MBGG
Summary of Contents for Candy CDG6MBGG
- Page 1 Cooker Hood Model CDG6MBGG / CDG9MBGG Instructions...
- Page 2 Information and advice CAUTION:Accessible parts may become hot when used with cooking appliances. In certain circumstances electrical appliance may be a danger hazard. A) There must be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning gas or other fuels. B)Do not check the status of the filters while the cooker hood is operating.
- Page 3 Information and advice CAUTION:Accessible parts may become hot when used with cooking appliances. J)If the supply cord is damaged,it must be replaced by the manufacturer,its service agent or similarly qualified persons in order to avoid a hazard. K)This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Page 4 1.Oil Filter 2.Filter aseembly 3.Air duct assembly 4.Glass 5.Main body assembly 6.Outter chimney...
- Page 5 3x 8 MIN350mm MIN350mm MIN500mm MIN500mm 650mm-750mm...
- Page 6 2 x 8 4x35mm 8x40mm...
- Page 8 8x40 mm 4x35 mm...
- Page 9 4x10 mm...
- Page 10 Do not touch the light bulb within half an hour after appliance use. The lamp shall not be covered with thermal insulation or other material...
- Page 11 Charcoal filter installation Care and Maintenance IMPORTANT: DO NOT ATTEMPT TO MAINTAIN OR CLEAN THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. To ensure the best performance from your cooker hood, the charcoal filter should be replaced every 3-4 months, dependent on use. Check with your local retailer or dealer for information on how to obtain replacement charcoal filters.
- Page 12 Replacement and maintenance 220-240V 1WX2 MAX CAUTION: LED lights replacement must be done by a qualified electrician. 1.Remove the LED lamp by flat-head screwdriver. 2.Pull out the LED lamp. Unplug the lamp wire connector. Replace the LED lamp. 3.Plug wire connector with new lamp. Push the LED lamp into the hole with sound of snap.
- Page 14 This appliance is labelled in accordance with European Directive 2012/19/EU on Waste Electrical and Electronic Equipment Regulations 2013 regarding electric and electronic appliances (WEEE). The WEEE contain both polluting substances (that can have a negative effect on the environment) and base elements (that can be reused).
Need help?
Do you have a question about the CDG6MBGG and is the answer not in the manual?
Questions and answers