Table of Contents
Advertisement
Operation Manual
KAKA Industrial
STOCK REQUIRED
⁄
3
2
-in. stock;
-in. max. width
16
One 10-in. blank
Setup
Make chalk marks on the blanks as
shown on the "Bend Sequence."
Bend No. 1
Insert the blank into the Bender to the #6
chalk mark, (as in A), and bend it to 45˚.
Recheck the angle before you go on to
the second bend.
Chalk mark the ring, or set a stop, for
ease of repeating the 45˚ bend.
Bend No. 2
Slide the stock to the #15 chalk mark (as
in B), and bend it to 45 ˚ . Recheck the
angle.
Bend No. 3
Slide the stock to the #24 chalk mark (as
in C), and bend it to 45 ˚ . Recheck the
angle.
To remove the part from the Bender,
®
remove
the
sharp-angle-bend attachment.
BEND SEQUENCE
Finishing
Grind and sand all sharp corners.
- 29 -
pin
that
holds
3
2
1
⁄
⁄
"│
"
1
1
1
│
│
1
2
1
4
2
Mark
YP-38
the
⁄
"│
4
Advertisement
Table of Contents
