One - KAKA Industrial YP-38 Operation Manual

Operation Manual
KAKA Industrial
STOCK REQUIRED
⁄
3
2
-in. stock; -in. max. width
16
14

One

-in. blank
3
One -in. Blank
Setup
Make a letter "C" as shown on page 23.
Bend Insert the 3-in. blank into the
Bender to the chalk mark, and bend it to
90˚. Recheck the angle.
To remove the part from the Bender,
remove the pin
sharp-angle-bend attachment.
Finishing
Position the 3-in. piece as shown and
tack-weld it. Grind and sand all sharp
corners.
BEND
│ 1" │
that holds the
3"
1"
- 27 -
®
STOCK REQUIRED
⁄
3
2
-in. stock; -in. max. width
16
6
One -in. blank
⁄
3
3
One -in. blank
4
Setup
None.
Finishing
Tack-weld the pieces together as shown.
Recheck that the pieces are at 90 ˚
angles to each other.
Grind and sand all sharp corners.
YP-38