16 -In. Stock; 2 -In. Max. Width - KAKA Industrial YP-38 Operation Manual

Operation Manual
Model YP-38
Bend No. 4
Slide the stock to the #10 chalk mark (as
in D), and bend it to 90 ˚ . Recheck the
angle. Check that the top and bottom of
the "E" re parallel.
To remove the part from the Bender,
remove the pin
sharp-angle-bend attachment.
Finishing
Tack-weld the 3
between the legs of the "A," parallel to the
top edge.
Grind and sand all sharp corners.
that holds
⁄
1
-in. insert piece
2
STOCK REQUIRED
⁄
3
-in. stock;
16
⁄
3
10
One 8-in. blank
⁄
1
2
One -in. blank
2
the
Setup
Make a letter "L" as shown on page 31.
Finishing
Position the 2
tack-weld it.
Grind and sand all sharp corners.
- 26 -
2
-in. max. width
⁄
1
-in. piece as shown and
2
3"
YP-38