Startup - Hoshizaki DCM-750BAH Instruction Manual

H. Startup
1. All parts are factory-adjusted. Improper adjustments may result in failure.
. If the icemaker is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
1) Open the water supply line shut-off valve.
) Remove the front panel. Move the power switch to the "ON" position and move the
control switch to the "OFF" position. See Fig. 4. Replace the front panel in its correct
position, then turn on the power supply.
Note: This unit will not run without the front panel in position.
3) Move the control switch to the "ICE" position to start the automatic icemaking process.
4) Once the unit starts to produce ice, allow it to run for another 30 minutes.
5) Move the control switch to the "DRAIN" position and allow the water system to drain for
5 minutes.
Note: If the unit is running, the drain valve will not open until .5 minutes after the
control switch is moved to the "DRAIN" position. This allows the components to
cycle down.
6) Move the dispense mode switch to the "CONTINUOUS" position and dispense all of the
ice from the storage bin.
7) Move the control switch to the "OFF" position, then turn off the power supply. Remove
the front panel, then move the power switch to the "OFF" position.
8) Remove the front cover of the storage bin. Clean the storage bin liner and the front
cover of the storage bin using a neutral cleaner. Rinse thoroughly after cleaning.
Replace the front cover of the storage bin in its correct position.
9) Move the power switch to the "ON" position and replace the front panel in its correct
position. Turn on the power supply, then move the control switch to the "ICE" position to
start the automatic icemaking process.
Fig. 4
CAUTION
Power Switch
Control Switch
Dispense Mode Switch
19