Sony TA-VE800G Operating Instructions Manual page 15

When programming the IR code, point the remote
at the IR sensor on the amplifier from a distance
no greater than 10 cm (4 inches) and hold down
the button on the remote for about 5 seconds until
the instruction "RELEASE YOUR
COMMANDER" appears.
IR sensor
Keep the remote pointed horizontally at the IR
sensor until the code is programmed.
If you tilt or move the remote during the
programming process, the IR code may not be
programmed correctly.
7
Repeat this procedure for the remaining buttons
that appear on the TV screen. If an IR code was
not programmed correctly, the IR code setting
indicator will flash.
To exit to the main menu
Click EXIT.
To return to a previous menu
Click RETURN.
To erase TV IR codes
Click CODE CLEAR.
• To erase a specific IR code
1 Click SINGLE IR CODE CLEAR.
2 Click the button you want to clear.
"Are you sure?" appears for confirmation.
3 Click YES to erase the code.
"CODE CLEAR!" appears in the display.
To stop before erasing a code, click NO.
To erase another code repeat steps 2 and 3.
• To erase all the TV IR codes
1 Click TV IR CODE CLEAR.
"Are you sure?" appears for confirmation.
2 Click YES to erase the codes.
"CODE CLEAR!" appears in the display. To stop before
erasing the codes, click NO.
• To erase all the IR codes
1 Click ALL IR CODE CLEAR.
"Are you sure?" appears for confirmation.
2 Click YES to erase the codes.
"CODE CLEAR!" appears in the display. To stop before
erasing all the codes, click NO.
Preparing and Using the Remote
Notes
• Some IR codes may not have been successfully
programmed, even if "RELEASE YOUR COMMANDER"
appears on the TV screen. In this case, try programming
the IR code again. If the IR code still cannot be
programmed, follow the procedure described in
"Programming Other Infrared (IR) Codes (USER IR
setting)" on page 20.
• With certain TV sets, made by other manufacturers, you
may not be able to programme the ZOOM button.
In such a case, use the remote supplied with your TV for
this operation.
To change from another manufacturer's TV set to a Sony
TV set
Connect the amplifier's MONITOR OUT jack to the VIDEO 1
input jack of the Sony TV set. Follow steps 1 to 3, then click
SONY TV in step 4.
15 GB