RAB X17 XFU 80 Instructions

INSTRUCTIONS
X17™ XFU 3-WAY FIELD ADJUSTABLE FLOODLIGHT
SELECTABLE PHOTOCELL INSTALLATION
RAB Lighting is committed to creating high-quality, affordable, well-designed and energy-efficient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We'd love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: marketing@rablighting.com
X17 XFU 80/60/40W Knuckle
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is
required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining xture. No user serviceable parts inside.
WARNING: Do not use an electric generator to test LED xtures.
WARNING: Min 75°C SUPPLY CONDUCTORS.

KNUCKLE MOUNT

To ensure weatherproof seal, apply weatherproof silicone sealant
around the edge of the Junction Box (not supplied). This is especially
important with an uneven wall surface.
1. Secure the fi xture to a 1/2" NPS hole in the junction box or
landscape post as shown in Fig. 1. Seal arm thread using
Tefl on® tape or silicone sealant.
2. Make appropriate wire connections per NEC in an approved
enclosure (not included) see Fig. 12.
3. The Knuckle Arm allows 180° of vertical aiming adjustment
depending on the mounting position as shown in Fig. 2.

TRUNNION MOUNT

Trunnion Mount accessory included.
To Install the Trunnion:
1. Remove the pre-installed Knuckle Mount by loosening the
Socket Head Screw and removing Bracket A as shown in Fig. 3.
2. Loosen 2 Socket Head Screws to remove Bracket B as shown in
Fig. 4.
3. Insert Fixture wires through the Trunnion and align with Fixture
M6*16 socket head screws
screw holes. Secure the Trunnion to the Fixture by tightening 2
Socket Head Screws as shown in Fig. 5.
M6*16 socket head screws
Fixture
Bracket A
Slipfitter Mount
X17 XFU 80/60/40W Trunnion
Fig: 1
Fig: 3
Fixture
Slipfitter Mount
Screws
Socket Head Screw
Wire
Tenon
Fig: 5
Wire
Fixture
Screws
Slipfitter Mount
Tenon
Wire
Trunnion
X17 XFU 80/60/40W Slip tter
Fig: 2
Knuckle Arm
Fig: 4
Bracket A
Screws
Bracket B
Bracket A
Tenon
Fig: 6
Angle Lock Screw
Socket
Head Screw (2)
Pole
Pole
Pole
Pole
Socket
)
Head Screw (2
M6*16 socket head screws
Pivot Bolt