Removing The Top Panel And Motor - Pioneer YD024GMFI18MR2 Installation Instructions Manual

HIGH VOLTAGE WIRING

6.3 REMOVING THE TOP PANEL AND MOTOR

NOTE:
Damage will occur to condenser unit
if you remove fan nuts prior to cover removal.
When motor requires changing follow the steps below:
Step 1: Go into electrical panel, disconnect motor power lines.
IMPORTANT NOTE
Disconnect main power to unit. Severe burns and electrical shock will occur if
you do not disconnect main power.
Step 2: Remove cover (be careful of motor wires)
Step 3: Be sure to place fan cover unit on the ground as indicated in Fig. 12
IMPROTANT NOTE
Do not place or lean fan blades on ground or against surface.
Step 4: Remove fan motor by removing 5/16" nuts from cover.
Step 5: Remove fan blade from motor by removing 1/2" nut and place fan on the ground.
Step 6: Reverse removal process to reinstall the fan and motor.
IMPROTANT NOTE
When connecting motor wires be sure to check motor direction.
LOW VOLTAGE WIRING
Fig.11 Typical Field Wiring
Fig.12 COVER AND FAN
CORNER
PANEL
1/2" nut
5/16" nuts
15