Honeywell Enviracaire 17005 Owner's Manual page 6

Customize Program Cycles: Model 17005
NOTE: The air purifier cannot be programmed unless it is plugged into the outlet.
To SET program points:
Press the SET button and hold for 3 seconds to activate time function. The SET button
will move through these programming functions:
Set (current) TIME.
Set PG1 cycle times P1-ON and P1-OFF.
Set PG2 cycle times P1-ON and P1-OFF, and P2-ON and P2-OFF.
Set EXIT mode and Run the clock.
To Customize the PG1 Program Settings to run ONE ON/OFF Cycle
in a 24 hour period:
NOTE: You are unable to set the OFF time to be the same as the ON time.
• Press the SET button and hold for 3 seconds to activate time function. Move
through programming functions by repeatedly pressing SET button until PG1 and
P1-ON appear. The clock and program speed icons will appear (Fig. 4a).
• Adjust the time using the hours and minutes button (up for hours, down for minutes).
This is the time that the machine will turn ON.
• Adjust the desired speed setting using the SPEED button.
Fig. 4a
• Press the SET button until PG1 and P1-OFF appear. The speed icon will disappear
(Fig. 4b).
• Adjust the time using the hours and minutes button. This is the time that the machine
will turn OFF.
• Repeatedly press SET button until (
• Press the PROGRAM button until PG1 appears. Unit will automatically operate per
your settings.
To run TWO customized ON/OFF cycles in a 24 hour period (PG2):
NOTE: You are unable to set the OFF time to be the same as the ON time.
The P2-ON time must be set for after the P1-OFF time.
6
Fig. 4b
6) disappears.