Honeywell Enviracaire 17005 Owner's Manual page 4

Operation: Model 17000
LOCATE PRE-FILTER IN THE BOX AND INSTALL BEFORE
INITIAL OPERATION.
Refer to "Removing/Changing the Filters" section for
proper installation.
• Ensure the air purifier is plugged into a working electrical outlet.
• Allow the unit to operate for a few seconds at HIGH speed,
then set the unit to HIGH or MEDIUM for faster, more powerful
room cleaning, or press the LOW button for quieter operation.
It is recommended you run your air purifier 24 hours a day to
ensure continuous cleaning. Portable air purifiers are more
effective in rooms where all doors and windows are closed.
Intelli-Check
The Intelli-Check
™
LifeTime HEPA Permanent Filter and when to replace the carbon pre-filter. Depending
™
upon your individual usage (environment and hours used), you may need to clean/replace
the filters more or less frequently.
When the HEPA Filter Indicator Light turns on, it's time to clean your HEPA filter. The
Intelli-Check reminder for when to clean the HEPA filter is intended as a guideline only as
™
the performance of the filter media is dependent on the concentration of the contaminants
to which the system is exposed. If there are sources of large amounts of contaminant
generation (such as dust from woodworking or heavy smoking) the HEPA filter in your air
purifier may need to be cleaned more often. For instructions on how to clean your HEPA
filter, refer to section "Cleaning the LifeTime HEPA
When your Pre-filter Indicator Light turns on, it's time to replace your pre-filter. It should
be replaced at least every 3 months. If there are heavy concentrations of odors, smoke,
or large particles in the home, you may need to change the carbon pre-filter more often.
For instructions on how to replace your pre-filter, refer to section "Removing/Changing the
Filters" in this manual.
Note: We do not recommend operating the air purifier without the carbon pre-filter.
Reset Filter Indicator/Turn Light Off: Model 17000
To Reset Filter Indicator
• Once the filter has been checked and cleaned or replaced as
needed, the filter indicator will need to be reset.
• With the unit powered on, press and hold the appropriate filter
indicator button down for approximately 10 seconds until the light
turns off (Fig. 1).
4
Filter Indicator: Model 17000
™
Filter Indicators serve as a convenient guideline for when to clean the
Permanent Filter" in this manual.
™
Fig 1