Honeywell Enviracaire 17005 Owner's Manual page 5

Set-Up: Model 17005
• CONNECT THE BATTERY. The programmable controls
and real time clock are battery backed. Upon initial set-up,
pull the protective film from the battery door so the battery
will make contact and function (Fig. 2). This battery allows you
to temporarily unplug your air cleaner without losing program
settings.
• INSTALL PRE-FILTER BEFORE USE. Locate the pre-filter in
the packaging. Refer to the "How to Install and Replace the
Filters" section for proper installation.
• SET CURRENT TIME. Plug unit in outlet.
NOTE: The air cleaner cannot be programmed unless it is plugged into the outlet.
Hold SET button down for approximately 3 seconds. The clock icon and word TIME
will appear. You may adjust the hours using the up button and adjust the minutes
using the down button. After the current time is set, repeatedly press SET button until
( ) disappears.
Manual Operation: Model 17005
The default program setting upon initial start-up is Manual Operation.
• To go from Automatic Operation to Manual Operation press the PROGRAM button
until both PG1 and PG2 disappear.
• To change the speeds in Manual Operation mode press the SPEED button to select
the desired setting.
• The SPEED button will move through HIGH, MED, LOW, and OFF as noted on the
display, and will function independent of programmed settings.
Pre-set Program Cycle: Model 17005
To run one pre-set program cycle in a 24 hour period (PG1).
PG1 Pre-Setting to run Program One
P1-ON 4 PM HIGH SPEED
P1-OFF 8 AM
To activate pre-set PG1, Press the program button once. PG1 will be displayed. Your
machine is now programmed to run from 4pm to 8am on HIGH (Fig. 3a, 3b).
Fig. 3a
Fig. 2
Fig. 3b
5