On-Screen Display (Osd) - Panasonic Omnivision PV-C2061 Operating Instructions Manual

On-Screen Display (OSD)

VCR Status & Clock Display
Press DISPLAY
to display or remove the overlay.
Function Status
Rec Time Remaining
12
(OTR mode only, see 12
CH
page 14.)
Receivable Broadcast
Types (See page 17.)
Time Stamp Data (See page 36.)
Warning and Instruction Displays
OSD
NO CH FOUND PLEASE CHECK
ANTENNA CABLE CONNECTION THEN
PUSH CH UP KEY AGAIN
PLEASE SET CLOCK BEFORE
PROGRAMMING
CHECK CASSETTE RECORD TAB
TO CANCEL TIMER REC HOLD DOWN
STOP KEY FOR APPROX 3 SEC
NO CASSETTE
PLEASE INSERT A CASSETTE
REMOTE CONTROL IS SET
TO DSS/CABLE MODE
USE COMBO : COMBO KEY
VIDEO HEADS MAY NEED CLEANING
PLEASE INSERT HEAD CLEANING
CASSETTE OR REFER TO MANUAL
END: PLAY KEY
VCR LOCK ACTIVATED
Channel Caption
(See pages 34, 35.)
Current Time
ON
ABC
REC 1 2 : 0 0PM
1
0 : 25 -0 : 1 2 : 3 4
0 8 ABC MO
STEREO SP
SAP
MONO
12 / 2 7 / 1 9 9 9 MON
12 : 0 0PM - 1 : 0 0PM
CH 0 8 ABC MO V I E
Caution
• If no active channels are found for CHANNEL MEMORY...
• If you attempt to set or review a Timer Recording, VCR
Plus+ System Programming or set the On-Timer and the
Clock is not set...
• If you press REC, and a cassette is inserted with no
record tab...
• If you press STOP during a Timer Recording...
• If you press PLAY, FF, REW, or REC without a cassette
inserted...
• If you press POWER, ACTION, or PROG on the remote
while in DSS or CABLE mode...
• If head cleaning becomes necessary while playing back
a tape...
• If you press a function button other than STOP/EJECT or
POWER while the unit is in VCR Lock mode...
Blue Screen Display
Whenever a blank section of a
tape comes up in Play mode, or
when the selected channel has no
broadcast signal with the Weak
Signal Display set to "OFF" (see
page 33), the screen will turn solid
blue.
Channel & Function Display
Counter
When a function button is pressed
(PLAY, FF, etc.) or you change
Tape Speed
channels, the unit mode or channel
number will be displayed. (Some
station names may also appear if
Channel Caption is set. See pages
34, 35.)
These displays will alert you to a missed
operation or provide further instructions.
0 8
ABC
Page
8 - 11
8 - 13
4, 14
25
14
28, 29
42
33
41