Panasonic Omnivision PV-C2061 Operating Instructions Manual page 27

* Important: if a remote control button does not work when pressed, press the COMBO button on
the remote and try the button again.
Ready Check List
The clock is set to correct time.
VCR Plus+ System Setup is
complete. (See page 26.)
Use normal Timer Recording steps if:
• a program PlusCode programming number
is not listed.
• program, such as a sporting event, may run
over scheduled stop time.
See page 25 to:
• cancel a timer recording in progress.
• replace program contents.
• review or clear program contents once set.
Notes
• You can obtain unlisted PlusCode
programming numbers by calling
1-900-454-7587.
Call costs approximately $.95 per minute.
• Avoid overlapping program times.
• If you're using a cable box, make sure that
it is tuned to the desired channel and the
power is left on for timer recording.
• Timer programs memory capacity is 8.
To add more programs, please first clear
other programs. (See page 25.)
• Make each entry within 5 minutes or the
unit will leave this mode.
• Once local channels have been
programmed, they will stay in memory,
even in the case of a power failure.
VCR Plus+ and PlusCode are
registered trademarks of Gemstar
Development Corporation.
The VCR Plus+ system is
manufactured under license from
Gemstar Development Corporation.
Notes
VCR Plus+ System Programming
1
Press PROG/VCR+
to display SET PROGRAM screen.
2
SET PROGRAM
T I MER PROGRAMMING
VCR P l u s + PROGRAMMING VCR P l u s + PR OGRAMMING
ON TIMER
SELECT :
SET :
END : PROG
3
VCR Plus+ SYSTEM
ENTER PLUSCODE NUMBER
US I NG 0-9 KEYS
END : PROG
To Make Corrections
Press repeatedly to delete
the PlusCode programming number.
4
VCR Plus+ SYSTEM
ONCE
DA I LY (MON-FR I )
WEEKLY
SELE C T :
SET :
END : PROG
5
DATE START STOP
28 28 TUE TUE 12 12:00 00P 12 12: 30 30P 69 69
CATEGORY : N / A
- - - - - - - - -- - - - - - - -- - - - - - -
SELE CT CATEGOR SE GORY
SELECT :
SET :
END : PROG / ACT I ON
Selections:
• Categories N/A (not applicable), SPORTS,
MOVIE, COMEDY, MUSIC, or DRAMA
• Speed SP, LP, or SLP
To Make Corrections
Press to move the cursor and
correction.
6
P DT START STOP
1 day 9 : 00 00 p 12 12 : 00 00a 08
2 -- -- : -- -- : --
3 -- -- : -- -- : --
4 -- -- : -- -- : --
CANCEL : ADD / DLT
SELECT 1 - 8 :
ENTER :
END : PROG / ACT I ON
7
Press PROG/VCR+ twice (or ACTION)
to exit this mode.
• PROG TIMER indicator lights on the unit.
1) Press
VCR Plus+
PROGRAMMING.
2) Press to display
screen.
1) Press number keys
to enter PlusCode
programming number.
2) Press PROG/VCR+
when finished.
1) Press
and to set
Record Frequency.
1) Press
CH
and to set
PBS
Category and
SP
Record speed.
to make the
Press PROG/VCR+
CH SPD
08 SP SP
(or ACTION.)
-- --
-- --
to end programming.
-- --
to select
to select
to select
27