Panasonic Omnivision PV-C2061 Operating Instructions Manual page 32

Tape Operation (continued)
Repeat Play
Set to see a recording over and over.
1
Press ACTION*
to display MAIN MENU.
2
M A I N MENU
T V VCR LANGUAGE
C H CLOCK
SELECT :
SET : ACT I ON
3
SET UP VCR
REPEAT PLAY PLAY
T I MER PROGRAMMING
T I ME STAMP
REMOTE WARN I NG
SELECT :
SET :
END : ACT I ON
4
Press ACTION twice
to end setup.
Zero Search
To quickly return to a specific tape counter location.
1
Press DISPLAY during playback
to display the Counter.
2
BEG I N END
3
Continue playback, rewind, or
fast forward.
4
Press STOP.
5
BEG I N END
• : Present position mark
: Zero position mark
• Unit goes into FF or REW mode and
stops at the last point the Counter was
set to 0:00:00.
32
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
1)Press
to select "VCR."
2)Press ACTION
to display SET
EX I T
UP VCR screen.
1)Press
select "REPEAT
: OFF FF
PLAY."
: ON
: ON
2)Press to set
REPEAT PLAY
"ON" or "OFF."
Press COUNTER
0 : 00 : 00
RESET at the
desired position to
reset to "0:00:00."
Press CM/ZERO
1 : 23 : 45
in stop mode to
start ZERO
SEARCH.
Commercial Skip
By pressing the CM/ZERO button in Playback
mode you can skip over 1 to 3 minutes of
recorded tape in just a few seconds.
1
Press CM/ZERO repeatedly to
select skip time in Play mode.
• No indication appears.
to
Repeat Play Notes
• Playback repeats when tape end is reached
or unrecorded portion over 30 seconds is
detected.
• During playback, you may also press
PLAY/REPEAT repeatedly on the unit to
select REPEAT "ON" or "OFF."
Zero Search Note
• If a blank portion exists on the tape, and
depending on the position of the
the mark display may be out of position.
mark,