Zanussi ZFU27400WA User Manual page 16

ance if it is damaged. Report possible dam-
ages immediately to the place you bought it.
In that case retain packing.
• It is advisable to wait at least four hours be-
fore connecting the appliance to allow the
oil to flow back in the compressor.
• Adequate air circulation should be around
the appliance, lacking this leads to over-
heating. To achieve sufficient ventilation fol-
low the instructions relevant to installation.
• Wherever possible the back of the product
should be against a wall to avoid touching
or catching warm parts (compressor, con-
denser) to prevent possible burn.
• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
Service
• Any electrical work required to do the serv-
icing of the appliance should be carried out
16
by a qualified electrician or competent per-
son.
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in
either its refrigerant circuit or insulation materi-
als. The appliance shall not be discarded to-
gether with the urban refuse and rubbish. The
insulation foam contains flammable gases: the
appliance shall be disposed according to the
applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit,
especially at the rear near the heat exchanger.
The materials used on this appliance marked
by the symbol are recyclable.
www.zanussi.com