Part Names; Projector - Hitachi CP-X4 User Manual

Part names

Part names

Projector

(1) Lamp cover (61)
The lamp unit is inside.
(2) Focus ring (18)
(3) Zoom ring (18)
(4) Control panel (5)
(5) SD card slot cover (10)
(6) Elevator knobs (x 2) (18)
(7) Elevator feet (x 2) (18)
(8) Lens (14, 65)
(9) Lens cover (3)
(10) Intake vents
(11) Filter cover (63)
The air filter and intake vent are inside.
(12) Speaker (35)
(13) Exhaust vents
(14) AC inlet (11)
(15) LAN port (8)
(16) USB STORAGE port (8)
(17) USB port (8, 13)
(18) COMPUTER IN port (8)
(19) VIDEO port (8)
(20) S-VIDEO port (8)
(21) Security slot (11)
(22) Shutdown switch (68)
(23) AUDIO OUT port (8)
(24) AUDIO IN port (8)
WARNING ►HOT! : Do not touch around the lamp cover and the exhaust
vents during use or just after use, since it is too hot.
►Do not look into the lens or vents while the lamp is on, since the strong light
is not good for your eyes.
►Do not handle the elevator knobs without holding the projector, since the
projector may drop down.
CAUTION ►Maintain normal ventilation to prevent the projector from heating
up. Do not cover, block or plug up the vents. Do not place anything that can stick or
be sucked to the vents, around the intake vents. Clean the air filter periodically.
►Do not use the security slot to prevent the projector from falling down, since it
is not designed for it.
►Use the shutdown switch only when the projector is not turned off by normal
procedure, since pushing this switch stops operation of the projector without
cooling it down.
4
HOT! (1)
(7)
(10)
(Bottom)
(12)
(13)
COMPUTER IN1 COMPUTER IN2
S-VIDEO
K
VIDEO
(15) (21) (16) (17) (22) (18) (19) (20) (23) (24)
USB STORAGE USB
DC 5V 0.5A
LAN
K
(2) (3) (4)
(6)
(7)
(9) (8) (11)
(14)
AUDIO OUT
USB USB STORAGE
HOT!
DC 5V 0.5A
AUDIO IN
AUDIO OUT
COMPUTER IN
AUDIO IN
S-VIDEO
VIDEO
(5)