Toro 41605 Installation Instructions Manual page 9

Spraying with the Hand
Sprayer
1. Remove the desired amount of hose from hose hooks.
Important: Do not pull the hose with the spray
gun. Always hold the hose and pull on it directly.
Pulling on the hose with the gun may break the
fitting on the gun or damage the hose.
2. Release the trigger lock.
3. Direct the spray gun nozzle at the area to be sprayed
and pull the trigger.
4. Release the trigger and set the trigger lock when
finished.
Switching from Hand Spray
Mode to Boom Spray Mode
1. Press the rate control switch to reduce the pressure.
2. Set the spray selection switch to the off position.
3. Direct the spray gun nozzle at an area where it is safe
to spray, release the trigger lock, and pull the trigger
until all remaining fluid is out of the hose, then set the
trigger lock.
4. Wrap the hose around the hooks of the tank and secure
the gun as shown in
9
Figure 14.
Figure 14