Table of Contents
Advertisement
g0286 38
1. Locknut (5/16 inch)
2. Washer (3/8 inch)
3. Hose hook
2. Install the spray-gun bracket assembly as shown in
Figure 3
using a carriage bolt (5/16 x 3/4 inch), a
washer (3/8 inch), and a locknut (5/16 inch).
3. Install the hose hook as shown in
carriage bolt (5/16 x 3/4 inch), a washer (3/8 inch),
and a locknut (5/16 inch).
3
Installing the Manual Valve
Parts needed for this procedure:
1
Manual valve assembly
4
Threaded rod
8
Locknut
6
Washer
8
Jam nut
Procedure
1. Loosen, but do not remove, the bolts that secure the
boom valve assembly to the right-hand mount bracket
(Figure
4).
1
2
3
4
5 2 1
Figure 3
4. Carriage bolt (5/16 x 3/4
inch) (2)
5. Spray-gun bracket
assembly
Figure 3
using a
1 2
1. Agitation valve
2. Left-hand mount bracket
2. Secure the boom valves together with 2 cable ties from
loose parts, and remove the right-hand bracket.
Note: As an alternative to this step, you may wish to
remove the boom hoses from the valves and move the
entire assembly to a workbench.
3. Remove the long bolts and fasteners that secure the
valve assembly
(Figure
Note: Discard the long bolts, but retain the washers
and locknuts.
Note: The valve assembly will no longer be anchored
to the machine at this point.
2
1
1. Locknut
2. Washer
3. Valve assembly
4. O-ring
5. Male to male adapter
4. Remove the pressure gauge port and the male to male
adapter
(Figure
Note: Save these parts for installing the manual valve.
5. Move the right-hand mount bracket away from the
existing valve assembly.
4
3
4
G020081
Figure 4
3. Bypass valve assembly
4. Right-hand mount bracket
5).
3
7
4 5 6
8
2
9
Figure 5
6. Pressure gauge port
7. Red tube
8. Right-hand mount bracket
9. Long bolts, existing
5).
G013885
Advertisement
Table of Contents
