Table of Contents
Advertisement
RUGGEDCOM WIN5137-V
Installation Guide
Section 5.1.4
ISED
This subscriber unit is declared by Siemens Canada Ltd to meet the requirements of the following ISED (Innovation
Science and Economic Development Canada) standard:
• RSS-197
Wireless Broadband Access Equipment Operating in the Band 3650–3700 MHz
Section 5.1.5
FCC
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
Subpart B , Part 90, and Part 96 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the device is operated in a commercial environment.
This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this device does cause harmful interference
to radio or television reception, which can be determined by turning the device off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to which the receiver is connected
• Contact Siemens Customer Support for assistance
IMPORTANT!
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this device.
Section 5.1.6
IEEE
This subscriber unit complies with the Mobile WiMAX Forum Wave 2 requirements defined by the following
Institute of Electrical and Electronics Engineers (IEEE) standards:
• IEEE 802.16-2005
IEEE Standard for Local and Metropolitan Area Networks – Part 16: Air Interface for Fixed and Mobile Broadband
Wireless Access Systems – Amendment for Physical and Medium Access Control Layers for Combined Fixed and
Mobile Operation in Licensed Bands
Section 5.1.7
RoHS
This device is declared by Siemens Canada Ltd to meet the requirements of the following RoHS (Restriction of
Hazardous Substances) directives for the restricted use of certain hazardous substances in electrical and electronic
equipment:
ISED
Chapter 5
Certification
25
Advertisement
Table of Contents
