Table of Contents
Advertisement
User Guide
mimic" LEDs) to the 20A position. Replace the fascia panel, and
the end cover.
• For a 20A supply, the maximum total load is 4600W
which can be made up of:
either: 1150W watts on each of the four channels
or: different loads on each channel so that the total does not
exceed 4600W (but not more than 2300W on any one channel)
or:
loads of up to 2300W may be connected to all four
channels provided that the unit is operated so that the total load
that is switched on at any one time does not exceed 4600W.
If connected to a lower capacity supply, or by a standard
British 13Amp BS1363 plug and socket, the output must be
reduced as follows:
• For a 16A supply, the maximum total load is 3680W
which can be made up of:
either: 920W watts on each of the four channels
or: different loads on each channel so that the total does not
exceed 3680W (but not more than 2300W on any one channel)
or:
loads of up to 2300W may be connected to all four
channels provided that the unit is operated so that the total load
that is switched on at any one time does not exceed 3680W.
• For a 13A supply, the maximum total load is 2990W
which can be made up of:
either: 745W watts on each of the four channels
or: different loads on each channel so that the total does not
exceed 2990W (but not more than 2300W on any one channel)
or:
loads of up to 2300W may be connected to all six
channels provided that the unit is operated so that the total load
that is switched on at any one time does not exceed 2990W.
Inductive loads:
If connecting inductive loads such as motors or discharge
lighting (metal halide, fluorescent or neon) to the Q-pedal, make
sure that the VA rating of the load does not exceed the figures
above (1150VA per channel, 3450VA total). The VA rating should
be labelled on the apparatus being connected. If the VA rating is
not known, reduce the maximum handling capacity to 800W per
channel, and 2400W total.
© NJD Electronics 2003
Q-PEDAL
-Page 3-
Advertisement
Table of Contents
