These instructions should be read carefully and left with the user of the product for future reference. Installation The Q-pedal is not fitted with a mains plug. This is because: a) it is capable of controlling more than 13 Amps b) it is an appliance for professional use.
Page 3
Inductive loads: If connecting inductive loads such as motors or discharge lighting (metal halide, fluorescent or neon) to the Q-pedal, make sure that the VA rating of the load does not exceed the figures above (1150VA per channel, 3450VA total). The VA rating should be labelled on the apparatus being connected.
Page 4
Sound input The Q-pedal has in internal microphone, so no connection to the audio source is required. However, when mounted on the floor it is likely to pick up sounds from the stage or the sound of the push-buttons being used.
96dB(A) on an average pair of PA speakers) OPERATION When first switched on,the Q-Pedal will be in blackout mode, with the Blue LED lit. The chaser will be running (as shown on the green LEDs to the right of the panel) but will not be connected to the outputs.
User Guide Q-PEDAL No LEDs lit • No mains supply Check the fuse in the supply to the Q-pedal. Check the mains supply. TECHNICAL SPECIFICATION. Size: 405mm × 201mm × 58mm Weight: 3.1kg Maximum load: 10 Amps per channel 2.3kVA @ 230V AC 2.3kVA corresponds to a resistive load of 2300 Watts or an...