Table of Contents
Advertisement
User Guide
Installer and Users please note:
These instructions should be read carefully and left with
the user of the product for future reference.
The Q-pedal is not fitted with a mains plug. This is because:
a) it is capable of controlling more than 13 Amps
b) it is an appliance for professional use.
Connect the Q-pedal to the mains supply with the built in mains
lead, Connect the wires as follows:
• Brown = live
• Blue = neutral
• Green/yellow = earth
• The Q-pedal must be earthed
Connect the output loads to the F321 sockets on the rear
panel using type F321BA plugs. Both sockets are connected the
same. Connections are shown below. Each channel of each socket
has its own 5 Amp fuse, so loads of more than 1150W per
Earth
Neutral
2
LIVE
1
filaments lamps, it should first be ascertained that the load is
suitable for switching on and off rapidly.
If used with a 16A or 20A supply then the internal Maximum
Current switch must be set accordingly.
Disconnect from the mains supply. Remove the left-hand end
cover (the opposite end to the mains cable) by removing the four
Torx screws using a Torx T20 Screwdriver. Slide out the fascia
panel. Move the 13A/20A switch (located adjacent to the "output
© NJD Electronics 2003
IMPORTANT
Installation
channel should be distributed over
the two sockets.
(It is good practice to distribute any
Neutral
load
so
3
supplying
LIVE
amounts of power).
4
If connecting any other load than
Q-PEDAL
that
both
sockets
approximately
-Page 2-
are
equal
Advertisement
Table of Contents
