Unilever Pure it CU3040 Instruction Manual page 3

EN
2) External thread faucet connection, only for M22X1 thread connection.
(The picture is for reference only, and the real product shall prevail)
3) Internal thread faucet connection, only for M24X1 thread connection.
(The picture is for reference only, and the real product shall prevail)
3. Whole machine installation
(The picture is for reference only, and the real product shall prevail)
Seal ring gasket
Faucet adapter fitting
- 4 -
4. Whole machine instructions.
Quick Start Guide
Following operations should be taken when the product is used for the first time.
Filters transposition: remove the CTO and UF filter from the machine, change the positions of 2 filters and install
them.
Rinse the filters: put the machine upside down, adjust the inlet faucet ball valve to make water flow into the machine,
keep water flowing out of the machine faucet for 5 to 10 minutes until the outlet water is clear and odor-free.
Restore the filter positions: turn off the water source, put the machine upside down and remove the CTO and UF
filter, install them in the original position on the machine, and then straighten the machine.
When first time to use this purifier, put the purifier upside down and adjust the faucet ball valve to make water flowing. Let
water entering the filter slowly toempty the air.When there is water coming out of the purifier, put purifier back to the regular
position and operating for 5 to 10 min, till output water is clean.Normally, just turn on the tap to get water. If need to use tap
water, switch the faucet ball valve to the inlet faucet. If don't use the machine for a long time, you should let it work for a while
before regularly drinking.
(The picture is for reference only, and the real product shall prevail)
When inlet tap is like pic.1, it provides tap water. When it is like pic.2, it pro-vides pure water.
(The picture is for reference only, and the real product shall prevail)
- 5 -
EN