Installation - Skil 3821 Owner's Manual

INSTALLATION

Mounting Applications
Workbench
Mount the saw using the four (4) bolt holes
(5/16") 1 to the workbench. Check for
clearance to the left and right of the saw
(Figure 15).
1. Each of the four (4) mounting holes should
be bolted securely using 5/16" bolts, lock
washers, flat washers and hex nuts (not
included).
2. Locate and mark where the saw is to be
mounted.
3. Drill four (4) 7/16" diameter holes through
workbench.
4. Place the compound miter saw on the
workbench aligning holes in base with holes drilled in workbench. Install screws, lock
washers, flat washers and hex nuts.
Supporting surface where saw is to be mounted should be examined carefully after mounting
to insure that no movement can occur during use. If any tipping or walking is noted, secure
the workbench or stand before operating the compound miter saw.
Portable Mounting Using Clamps
If necessary, clamp the compound miter saw
•
to a workbench or table top.
Place two (2) or more "C" clamps 2 on the
•
clamping areas and secure (Figure 16).
NOTE: Always make sure you leave enough
room in work area to accommodate long
workpieces.
Fig. 15
1
1
1
Fig. 16
1
1
2
27