Removing Cards From The Chassis; Removing Cards From The Line Card And Rp Card Cage - Cisco XR 12410 Installation Manual

Chapter 3 Installing the Cisco XR 12410 Router

Removing Cards from the Chassis

Removing Cards from the Line Card and RP Card Cage

Caution
Step 1
OL-17441-01
To reduce additional weight from the chassis, you can remove all line cards, RPs,
switch fabrics, and alarm cards. This section describes how to remove the various
types of cards.
The line card and RP card cage contains 10 slots (numbered 0 through 9, from left
to right). Line cards are installed in slots 0 through 7; RPs are installed in slots 8
and 9.
Handle all cards by the metal card carrier edges only; avoid touching the board or
any connector pins. After removing a card, carefully place it in an antistatic bag
or similar environment to protect it from ESD and dust in the optic ports
(fiber-optic line cards).
Use the following procedure to remove line cards and RPs from of the chassis.
Proceeding from left to right, identify each card and write down the card type and
slot number on a piece of paper
You will need this information when you reinstall the cards in the chassis
Note
to be sure you install them in the same card slots.
Cisco XR 12410 and Cisco XR 12810 Router Installation Guide

Removing Cards from the Chassis

(Figure 3-7).
3-11