Removing And Installing Gbics - Cisco XR 12000 Series Installation Manual

Use a Phillips screwdriver to insert and tighten the two screws on the faceplate of the line card,
Step 6
3 to 5 in-lbs, as shown in
Apply no more than 5 in-lbs of torque when tightening the screw.
Caution
Figure 15

Removing and Installing GBICs

Your Ethernet line card may have shipped with a GBIC installed. If your line card arrived without the
GBIC installed and you need to install it now, or if you need to change your GBIC for another reason,
use the procedures in these sections:
•
•
•
Before you remove or install a GBIC, read the installation information in this section and the
Safety" section on page
Note Cisco strongly recommends that you disconnect all fiber-optic cables before removing or installing a
GBIC.
OL-7861-01
Figure
Inserting the 2 screws on the Faceplate of the Line Card
General GBIC Handling and Maintenance Guidelines, page 24
Removing the GBIC from an Ethernet Line Card, page 24
Inserting a GBIC into the Gigabit Ethernet Interface, page 25
82.
15.
Cisco XR 12000 Series Router Ethernet Line Card Installation
Removing and Installing GBICs
"Laser
23