Cisco XR 12000 Series Installation Manual page 35

Figure 26
Removing a Slide Tab SFP Module
To remove this type of SFP module, follow these steps:
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 1
Disconnect and remove all interface cables from the ports; note the current connections of the cables to
Step 2
the ports on the line card.
Grasp the SFP module between your thumb and index finger.
Step 3
With your thumb, push the slide tab on the bottom front of the SFP module in the direction of the line
Step 4
card to disengage the module from the line card port. (See
Figure 27
With the tab still pushed, carefully pull the SFP module from the port as shown in
Step 5
Caution You must disengage the SFP module by pushing on the slide tab before you can pull out the SFP module.
If you pull on the SFP module without disengaging the tab, you can damage the SFP module.
OL-7861-01
Slide Tab SFP Module
Disengaging the Slide Tab
Cisco XR 12000 Series Router Ethernet Line Card Installation
Removing and Installing SFP Modules
Figure 27.)
Figure 28.
35