Cleaning And Servicing - Siemens EX9 KX Series Information For Use

23.3 Overview of the hood control settings
You can change the behaviour of your extractor hood in the basic settings of your hob, depending on switch-on/off
of the hob or individual cooking zones.
The display shows the settings only when the appliance has been connected to the extractor hood.
Setting
Fan control (automatic start)
Fan run-on
Automatic light activation
Automatic light deactivation
Disconnect
1
Factory setting (may vary according to model)
24 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
24.1 Cleaning products
You can obtain suitable cleaning products and glass
scrapers from customer service, a retailer or the online
shop siemens-home.bsh-group.com .
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶
Never use unsuitable cleaning products.
▶
Do not use cleaning products while the hob is still
hot. This may cause marks on the surface.
Unsuitable cleaning products
¡ Undiluted detergent
¡ Detergent intended for dishwashers
¡ Abrasive cleaning products
¡ Aggressive cleaning products such as oven spray
or stain remover
¡ Abrasive sponges
¡ High-pressure or steam jet cleaners
Selection
Switched off – The extractor hood must
be switched on manually, if required.
Switched on in automatic mode
automatic mode, the hood switches it-
self on when you switch on any of the
cooking zones.
Switched on in standard mode – The
extractor hood is switched on at a spe-
cified setting when a cooking zone is
switched on.
Fan off.
Switched on in automatic mode.
Switched on with standard fan run-on.
The fan settings cannot be adjusted
when the hob is switched off.
¡ Off
1
¡ On – The light is switched on when
the hob is switched on.
1
¡ Off
¡ On – The light switches itself off
when the hob is switched off.
-
Description
You can set whether/how the fan starts
when you switch on the hob.
1
– In
You can set whether/how the contin-
1
ues to run when you switch off the hob.
You can set whether the lighting for the
extractor hood switches on automatic-
ally with the hob.
You can set whether the lighting for the
extractor hood switches off automatic-
ally with the hob.
With this setting, you reset the saved
connections to the Wi-Fi or go back to
the extractor hood.
24.2 Cleaning the hob
Clean the hob after every use to stop cooking residues
from getting burnt on.
Requirement: The hob must be cold. Do not allow the
hob to cool down if it has sugar stains, plastic or alu-
minium foil on it.
1. Remove heavy soiling using a glass scraper.
2.
Clean the hob with a cleaning agent for glass
ceramic.
Follow the cleaning instructions on the packaging of
the cleaning agent.
Tip: You can achieve good cleaning results using a
special sponge for glass ceramic.
24.3 Cleaning the hob surround
If the hob frame is dirty or stained after use, clean this.
Note: Do not use a glass scraper.
1. Clean the hob frame with hot soapy water and a soft
cloth.
Wash new sponge cloths thoroughly before use.
2. Dry with a soft cloth.
Cleaning and servicing en
21