Fidelis Network CommandPost Quick Start Manual page 8

Complete the Appliance Network Configuration
1. After connecting using either KVM Console or iLO, you should see this screen for Fidelis Network
appliances version 9.4.1 or later.
If you do not see the screen shown above, contact
2. With Perform Initial Install or Factory Reset selected, press Enter.
3. Use the Up and Down arrow keys to select CommandPost+, and press Enter.
The system displays a screen with the message Congratulations, your CentOS installation is
complete. The system will automatically reboot.
4. Directly attach an ethernet cable from a client system such as a laptop to the Admin/eth0 port on
the appliance. The default IP address is 192.168.42.11/24. Assign a static IP from the same
subnet to the network interface on the client system and connect to the appliance using SSH.
.
Copyright © 2022 Fidelis Cybersecurity
®
, Inc. All rights reserved
Fidelis Technical Support.
8
www.fidelissecurity.com