Replacing The Power Nozzle Belt; Replacing The Bulb - Riccar RPB-F Owner's Manual

Replacing the power nozzle belt

• To replace the power nozzle belt, you
must first remove the brushroll (see
"Removing the brushroll"). Locate and
discard broken belt.
• To install a new belt, locate the power
nozzle motor pulley and loop the belt
around it (see diagram).
• Place the other end of the belt around
the brushroll making sure the belt
is seated in the "belt groove" of the
brushroll (see diagram).
• Insert the brushroll back into the
brushroll tray and place the belt guard
back into position.
• Place the metal bottom plate back on
to the unit (insert the front end of the
bottom plate first). Reinsert the two
bottom plate screws and secure.
Diagram 12
Belt
Diagram 13
Maintenance and Care

Replacing the bulb

• Turn the power nozzle over and remove
the bottom plate by first unscrewing the
two bottom plate screws located by the
rear wheels. Locate and remove the two
top cover screws (see diagram).
• Turn the power nozzle back over, push
the power nozzle neck flat, and remove
the top cover (see diagram). Simply pull
the bulb out (no twisting) and insert a
factory authorized bulb.
• Place the top cover back on the unit,
turn the machine over and reinsert the
two top cover screws. Reinstall the
bottom plate.
Top Cover Screw
Top Cover Screw
Diagram 14
Diagram 15
9