Contents IMPORTANT SAFETY INSTRUCTIONS Warranty Description of the Power Nozzle and Wand Operating the Power Nozzle Inserting the hose Turning on the power nozzle Using the power nozzle Removing / Inserting the wand from the power nozzle Adjusting the wand Carpet height adjustment Maintenance and Care Removing the brushroll...
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING: The manufacturer cannot accept responsibility for damage caused when the appliance is not used according to the instructions, or for uses other than those for which it was intended.
For warranty information visit: Riccar.com/warranty-information Leave a Review We want to hear from you! Please let us know what you think of your new vacuum by leaving a product review on Riccar.com.
Assembling and Operating the Power Nozzle & Wand Assembling the Removing / Inserting the wand from wand the power nozzle • Insert the wand into • Removing the wand from the power the power nozzle nozzle allows you to use accessory neck until the button tools for baseboard or ceiling cleaning.
Operating the Power Nozzle Carpet height adjustment • Your power nozzle has six different settings to clean a variety of carpet types and floor surfaces. To adjust the carpet height setting of the power nozzle, press the pedal located on the right rear side of the power nozzle (see diagram).
Maintenance and Care IMPORTANT: Before performing any • To remove the brushroll, turn the unit maintenance on the power nozzle, always over and lift off the metal bottom plate disconnect the hose from the vacuum by first unscrewing the two bottom plate inlet and unplug the power cord, if your screws located by the rear wheels (see model has one.
Maintenance and Care Replacing the power nozzle belt Replacing the bulb • To replace the power nozzle belt, you • Turn the power nozzle over and remove must first remove the brushroll (see the bottom plate by first unscrewing the “Removing the brushroll”).
Problem Solving Guide Power nozzle warning light • When the unit is turned back on, the warning light should be green • Your power nozzle comes equipped with a circuit breaker safety system that and ready to go. If the breaker trips protects it from a jammed power nozzle again, repeat steps a-c to correct the problem.
Page 11
• Replace / wash filter • Power nozzle belt is broken • Replace broken belt Any other service should be performed by an Authorized Riccar Vacuum Retailer. To locate your nearest Authorized Retailer, visit our website at Riccar.com or call 888-674-2227.
Need help?
Do you have a question about the RPB-F and is the answer not in the manual?
Questions and answers