COOKER HOOD Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. The hood is conceived for the suction of cooking fumes and steam and is destined only for domestic use.
Page 12
Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks. Never use the hood without effectively mounted grids. The hood must NEVER be used as a support surface unless specifically indicated. Use only the fixing screws supplied with the product for installation or, if not supplied, purchase the correct screws type.
The hood is designed to be used either for exhausting or filter version. Ducting version In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood. Attention! The exhausting pipe is not supplied and must be purchased apart.
OPERATION WHI651S1XGB - WHI951S1XGB - WHI661S2X - WHI961S2X To select the functions of the hood, simply touch the controls. T1. Standby mode (the control panel off – all functions disabled) / ON (control panel switched on) Note: After about a minute of inactivity (suction and lights), the hood will automatically switch to standby. T2.
Page 15
Hood Calibration With the display on (ON) and the suction off (OFF), press button T4 for 5 seconds. The suction speed (power) 2 starts functioning and button T4 flashes to indicate that hood calibration is initiated and it will last for approx. 15 minutes. Note: to interrupt the calibration, press T4 for 5 seconds;...
Page 16
WHI641A3B - WHI941A3B - WHI641A3XGB - WHI941A3XGB - WHI661A4X - WHI961A4X To select the functions of the hood, simply touch the controls. T1. Standby mode (the control panel off – all functions disabled) / ON (control panel switched on) Note: After about a minute of inactivity (suction and lights), the hood will automatically switch to standby. T2.
Page 17
Press the button T7 for the gas cooktop – the button flashes to indicate its selection. Press the button T8 for the electric cooktop- the button flashes to indicate its selection. WHI641E6XGB - WHI941E6XGB - WHI641E6B - WHI941E6B To select the functions of the hood, simply touch the controls.
Apply one on each side as cover to both the shield grids of the motor impeller, then turn clockwise. For the disassembly, turn counter-clockwise. Replacing lamps WHI641E6XGB - WHI941E6XGB - WHI621E1XGB - WHI921E1XGB - WHI641E6B - WHI941E6B - WHI621E3B - WHI921E3B Fig. 19 Disconnect the appliance from the electricity.
Page 28
الصيانة ل الشفاط عن التيار الكھربائي بقطع الرابط أو إزالة فيوز الرابط قبل تنفيذ أي عملية صيانة افص تنبيه أو إذا تم توصيل الجھاز بقابس ومقبس، فيجب إزالة القابس من المقبس التنظيف الداخلية على األقل بعدد مرات أعمال الصيانة التي تقوم بھا بالنسبة لفالتر الدھون يجب...
Page 29
ستبدال اللمبات ا WHI641E6XGB - WHI941E6XGB - WHI621E1XGB - WHI921E1XGB - WHI641E6B - WHI941E6B - WHI621E3B - WHI921E3B 19 الشكل افصل الجھاز عن التيار الكھربائي قبل لمس اللمبات تحقق أنھا باردة تحذير ب ي ّن على لوحة التصنيف أو بجانب اللمبة على الشفاط...
Need help?
Do you have a question about the WHI641E6XGB and is the answer not in the manual?
Questions and answers