Lens Mounting; Power Connection; Ethernet Cable Connection - Grundig GCI-N0503B Owner's Manual

8 megapixel cmos auto-back-focus box ip-camera icr

Table of Contents

Network Card :

10Base-T (10 Mbps) or 100Base-TX (100 Mbps) operation

Viewer :

ActiveX control plug-in for Microsoft IE

4.3. Lens Mounting

Lens Mounting for C/CS Mount Lens Model:

It is possible to attach all CS-Mount lenses with manual or DC controlled iris on the camera. Please remove the

camera's plastic covering first and then attach the CS-Mount lens onto the camera. If you would like to use a C-

Mount lens, you need a 5 mm C/CS Mount Adapter between the camera and the C-Mount lens, as shown in the

illustration below.

Please use a DC 12V / AC 24V power adaptor and plug it into the power connector of the camera and the power

outlet. If you wish to use an AC 24V power adaptor, please first plug the supplied Power Switch Connector into

the power connection of the camera. Alternatively, connect the Ethernet cable to the camera's PoE port and plug

the other end of the cable into a PoE switch.

NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in use in the network.

Use of Category 5 Ethernet cable is recommended for network connection. To have the best transmission quality,

the cable length shall not exceed 100 meters. Connect one end of the Ethernet cable to the RJ45 connector of the

IP Camera, and the other end of the cable to the network switch or PC.

NOTE: In some cases, you may need to use an Ethernet crossover cable when connecting the IP Camera directly

to the PC.

Check the status of the link indicator and the activity indicator LEDs. If the LEDs are unlit, please check the LAN

connection.

Green Link Light indicates good network connection.

Orange Activity Light flashes for network activity indication.

English

Table of Contents