Troubleshooting; Engine Won't Start; Generator Won't Produce Power; Engine - BOLIY Pro3600Si Owner's Manual

Digital generator
Hide thumbs Also See for Pro3600Si:
Table of Contents

Advertisement

ENGINE WON'T START

1. Fuel system, engine is not getting fuel..
• No fuel in tank... Supply fuel.
• Clogged fuel line... Clean fuel line.
• Foreign matter in fuel fi lter... Replace fuel fi lter.
• Clogged carburetor ... Clean carburetor.
2. Engine oil light fl ashes
• Oil level is low... Add engine oil.
3. Electrical system
• Engine switch to "ON". Poor or no spark.
• Spark plug is dirty... Replace spark plug.
• Faulty ignition system... Consult dealer.
4. Compression Insuffi cient
• Worn out piston and cylinder... Consult dealer.

GENERATOR WON'T PRODUCE POWER

Stop the engine, then restart. If A/C lights continue to fl ash consult your dealer.
STORAGE GUIDELINES
Long term storage of your machine will require some preventive procedures to guard against deterioration. The
following steps are necessary to protect your generator during long periods of storage.
DRAIN THE FUEL
1. Add fuel stabilizer to tank and run generator.
2. Remove the fuel tank cap. Drain the fuel from the fuel tank into an approved gasoline container using a
commercially available hand siphon. Then, install the fuel tank cap.
WARNING
• Fuel is highly fl ammable and poisonous.
• Wipe up any spilled fuel immediately.
3. Drain fuel from the carburetor by loosening the drain screw on the carburetor fl oat chamber.
4. Turn the fuel cock lever to "OFF". Start the engine and leave it run until it stops. This will burn any remain-
ing fuel in the carburetor.

ENGINE

1. Remove the spark plug, pour about one tablespoon of SAE 10W30 or 20W40 motor oil into the spark plug
hole and reinstall the spark plug. Turn over engine several times (with ignition off) to coat the cylinder walls
with oil.
2. Pull the recoil starter until you feel compression. Then stop pulling. (This prevents the cylinder and valves from rusting).
3. Clean exterior of the generator and apply a rust inhibitor.
4. Store the generator in a dry, well-ventilated place, with the cover placed over it.
5. The generator must remain in a vertical position when stored, carried or operated.
16

TROUBLESHOOTING

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro3600si/ePro3600si/er

Table of Contents