Table of Contents
Advertisement
en Troubleshooting
Fault
"E:30 / -10" and/or
"E:35 / -10"
46
Cause and troubleshooting
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
Water level measurement system is defective.
Note: With the error message, the appliance starts a
draining process.
First wait approx. 5 minutes until the drain process
1.
ends.
To reset the error message, switch the appliance
2.
off.
Switch the appliance back on.
3.
If the error message is displayed again, call cus-
4.
tomer service.
→ "Customer Service", Page 57
There is water in the base trough.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 57
The appliance is leaking.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 57
The detergent drawer has not been pushed in fully.
Push in the detergent drawer until the symbol goes
▶
out.
The pump unit is not inserted.
Insert the pump unit into the detergent drawer.
1.
→ "Cleaning the detergent drawer", Page 39
Push in the detergent drawer until the symbol goes
2.
out.
Advertisement
Table of Contents
